The Pro

The RTF-20Y is built for hard use: 20,000 m³/h of airflow, a 300-litre tank for more than 8 hours of continuous operation, 30 metres of air throw and a mains-water connection. Mobile on robust braked castors — cools where air conditioning gives up.

Colour: Cyan

€2,779

incl. VAT, plus €100 shippingDelivery time 3–6 working days

Recommended area: 220 m²
Airflow: 20.000 m³/h
Power draw: 1.100 W
Water tank: 300 L
Water consumption: 45 L/h
Air throw: 30 m
Noise level: 68 dB
Dimensions (W×D×H): 1.120 × 1.120 × 2.050 mm
Weight: 78 kg
Voltage: 220 V / 50 Hz

Guide

Ready to cool in a few steps.

Evaporative cooling takes a little know-how — here are the essentials for setup and care. Full details are in the manufacturer's manual.

Getting started

Fill with water

Fill the tank with clean, soft water through the inlet — the level window shows the fill. Always fill first, then switch on.

Switch on

Connect the unit to the mains and start it with the ON/OFF button. It first runs in pure ventilation mode.

Activate cooling

The cooling button starts the pump: water soaks the cooling pad and, after about a minute, noticeably cooler air flows out. The green light indicates cooling mode.

Set the airflow

Choose the fan speed, add the swing function for even distribution and set the timer if needed.

Care & maintenance

Safety first

Disconnect the mains plug before any maintenance.

Rinse the cooling pad and filter from the inside out every few weeks — no acids or harsh cleaners, at low water pressure.
Empty and rinse the water tank regularly to prevent deposits.
Before longer storage, empty the tank, run the unit dry for about ten minutes and store it dry.